PRODUCTS - PLASTER ACCESSORIES

PLASTER REINFORCING FABRIC

Fibreglass Reinforcement solutions that are less costly and more effective than steel. High performance, full strength, alkali-resistant products will not rot, rust or corrode.
They are also lightweight and easy to install and use. These innovative, superior alternatives to steel mesh are easy to work-with, will not rust or rot and provide
increased strength in every cementitious application.

Fibreglass Reinforcement Mesh is used for reinforcement of inside concrete floors and walls elimination of cracks during repair of thin concrete layers and other non-structural concrete applications in buildings.

Installation

Wet the surface thoroughly and apply a thin coat of plaster. Press the fabric gently with a trowel in the fresh plaster. Apply the final layer of plaster.

Advantage

High Alkali Resistant
Non Corrosive
Low Elongation
East to Install - No Hammering or Nailing
Excellent adhesion with all types of plaster.

Uses

To reinforce all types of plaster,applied externally or internally.
For load-bearing construction and general renovation work.
For repair work and general renovation application.
Preventing cracks in plastering.
As reinforcing base for gypsum or wooden surface

Technical Specification

Reference

Size (mm)

Mesh Size

5×5 mm ± 0.5 mm

Weave Construction

Warp : 5*2 per inch
Weft : 4.5 per inch

Warp Yarn

134 Tex glass yarn

Weft Yarn

400 Tex glass roving

Thickness

0.38 ± 0.02 mm

Coating

Alkali Resistant
(Tensile Strength retention
more than 50%)

Finish

Medium Hard

Total gsm

160 ± 5% gsm

Width

1000 mm

Feather Edge

Slit Edge

Length

50 M Roll

Tensile Strength

Warp 2400 N/5 CM with
Elongation- 4.0%
Warp 2000 N/5 CM with
Elongation- 4.0%